If that bothers you, you can always hold them upsidedown and shake the shavings out through the holes. Please contact our sales team online or by phone at 1-80 for questions regarding current order lead times. Lead times may vary based on order volume and seasonal demand. NOTE: because these shelves are enclosed, some wood shavings will get stuck inside during drilling. Wood Floating Shelves ship within 1 to 2 weeks, depending on the wood species and options selected. Once you reach final diameter, drill through the other two supports to get everything in line. Then enlarge the hole in steps out to your final diameter. When drilling the holes, use a drill press or drill guide with a small bit diameter to get a perfectly perpendicular hole on the first support piece only. Then you can mark the location of each post on the back of the shelf and drill the holes. I’ll also be using a sander to smooth my edges, but you can also just use a sanding sponge. Overall, I recommend attaching the brackets to the wall first to ensure everything is level and true. For this DIY floating shelf project, I’m using stock boards from the home center, a miter saw to cut them to length, and a drill/driver to assemble the pieces with screws and wood glue. Since I had three shelves I tried three different install methods: drilling and installing brackets into shelves first then marking locations on walls, installing brackets on wall first and then drilling holes in shelves, and a hybrid of the two that worked so poorly I won't even go into details. Make sure your clamps are in line with the supports or else you risk bowing or breaking the plywood. Installed the 1/4" plywood into the opening with stain side facing out and clamp everything until the glue sets. Once those are in place, liberally add glue to the top of each support as well as three edges of the 1/4" thk plywood piece. This probably isn't needed but it adds some sturdiness. Everything was glued down in place and I added some finish nails to the sides going into the supports. Then the remaining two supports were spaced off the first by using two 3/4" thick pieces of scrap wood. I inset the first piece about 1/2" from the edge to match the thickness of my Floating Shelf Brackets. When you are finished, people won't be able to notice the difference.Īfter the glue has set, you can start adding in the 1" thk support pieces. If there is a slight gap between the miters, lightly hit the corners with a hammer until the gaps are closed. I put some finish nails near the miters to hold those in place. Flush cut the extra length of the side rails when done so that they are in line with the plywood. Add the front and side pieces with the mitered edges using wood glue and clamp everything together. To assemble the shelves, lay down a piece of the 1/2" plywood, stain side down.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |